Hi everyone, I just got a 2big network, I connected my PC to the serial port and I got bad magic number error and the Marvell prompt. After loading a kernel using tftp, setting up the partitions i was able to get a fully functional debian unit. But there is still a problem, if I remove the power and turno on the device again the device doesn't start (bad magic number error) but if i write the reset command on the Marvell prompt, the system restart and this time everything is ok. The problem apparently is that the hardrive take too much time to start and the system try to boot before the HD is ready. There is a way to make a CPU restart using the buttons or other workarounds to this problem?.
Thank you very much.
Problem to boot my 2big
Post Reply
1 post
• Page 1 of 1
Jump to
- General
- ↳ Announcements
- ↳ Development
- ↳ General
- ↳ Kernel
- ↳ Foonas
- ↳ Everything else
- Hardware
- ↳ Lacie
- ↳ CloudBox
- ↳ d2 Network
- ↳ d2 Network 2
- ↳ EDmini
- ↳ EDmini v2
- ↳ Ethernet Big Disk
- ↳ Internet Space
- ↳ Network Space
- ↳ Network Space 2
- ↳ Network Space MAX
- ↳ Wireless Space
- ↳ 2big Network
- ↳ 2big Network 2
- ↳ 5big Network
- ↳ 5big Network 2
- ↳ Other
- ↳ Lenovo/Iomega
- ↳ EZ Media & Backup Center
- ↳ iConnect
- ↳ Home Media Network Hard Drive
- ↳ Home Media Network Hard Drive - Cloud Edition
- ↳ StorCenter ix2-200
- ↳ StorCenter ix4-200d
- ↳ StorCenter ix4-200r
- ↳ StorCenter ix4-300d
- ↳ Other
- ↳ Zyxel
- ↳ NSA210
- ↳ NSA-220/NSA-220 Plus
- ↳ NSA221
- ↳ NSA-2400/NSA-2401
- ↳ NSA-310/320/325
- ↳ NAS520/540/542
- ↳ Other
- ↳ Other Manufacturers
- ↳ Belkin
- ↳ Data Robotics Inc
- ↳ LG
- ↳ Medion
- ↳ Netgear
- ↳ Plextor
- ↳ Sitecom
- ↳ Shuttle
- ↳ Thecus
- ↳ Xtreamer
- ↳ Other
- Foreign
- ↳ German