General NAS-Central Forums

Welcome to the NAS community
It is currently Sun Aug 20, 2017 1:31 pm

All times are UTC




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Thu Mar 21, 2013 5:19 pm 
Offline

Joined: Thu Mar 21, 2013 5:15 pm
Posts: 1
Hi,

I have moved house recently, which resulted in;
A) New router, using 192.168.0.1 subnet range, whereas previously it was on 192.168.1.1
B) Installed a new hard drive into the NAS, as one wasn't detected (never was)

Now, I run the NAS Seeker software, but it doesn't find the NAS on the network. I have also pressed the RESET button on the back of the NAS until it beeped then started it again, with no luck on the NAS seeker software.

I expect the issue is due to the difference in IP ranges, but can anyone assist me in getting my NAS back please!

Thank you for your time


Top
 Profile  
 
PostPosted: Thu Mar 21, 2013 8:40 pm 
Offline

Joined: Mon Jun 16, 2008 10:45 am
Posts: 6022
SeedyAre wrote:
I have also pressed the RESET button on the back of the NAS until it beeped then started it again
How did you restart it? If you powercycled it, and didn't wait long enough before pulling the plug, the reset wasn't applied yet. The box starts resetting when you release the reset button.

Further, AFAIK a 'single beep' reset resets the admin password. For a full factory reset you should keep the reset button pressed until it has beeped three times. Then release the button, wait a minute, and press the power button to shut it down, if it didn't reboot automatically.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 5 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group