General NAS-Central Forums

Welcome to the NAS community
It is currently Tue Feb 20, 2018 12:08 am

All times are UTC

Post new topic Reply to topic  [ 3 posts ] 
Author Message
PostPosted: Fri Apr 05, 2013 7:18 am 

Joined: Sun Aug 19, 2012 11:54 am
Posts: 2
I upgraded to Firmware 4.40 a few days ago and things were fine. Last night I used the NAS to stream video, and it powers itself down at around 12 am. This morning I am unable to boot it. It blinks for about a minute, and then it shuts itself down.

From the NAS Starter Utility I can see that the device is in a state of Unreachable. It registers the drives properly and displays the used space properly on the NAS Starter utility, so the disks work.

If I hard reset it (3 beeps) and restore to factory defaults it does not help. But if I remove the disks then the nas boots up properly and I can connect.

What is wrong? Would it be necessary to downgrade to 4.21 firmware?


PostPosted: Fri Apr 12, 2013 8:59 pm 

Joined: Fri Apr 12, 2013 8:49 pm
Posts: 1
This is sounds almost exactly what has happend to my NAS. Zyxel support suggested the disks have failed but I've since booted the NAS up without the disks in and then hot pushed one of the disks in - I've been trying to copy off the files with some success to USB but everynowandagain the NAS hangs and is unreachable and the shares can't be found.
V. annoyed
Hope somebody can propose a solution

PostPosted: Mon Apr 15, 2013 6:49 pm 

Joined: Mon Jun 16, 2008 10:45 am
Posts: 6166
Do you by chance have any packets installed, from the previous firmware?

Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC

Who is online

Users browsing this forum: No registered users and 4 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group