I have a 2big network V2. It fucked up an update and was stuck in a flashing blue light loop. I read up on everything, took out the drives and reinstalled the firmware as in the NAS wiki.
If I boot up the NAS it boots perfectly. If I go through the reset protocol it will (appears to at least) reset.
However, if I have the ethernet cable installed it doesn't progress in booting past the flashing blue light stage, and if I put the ethernet cable in while it's booting or booted, it immediately starts the flashing blue light loop.
If the cable is not plugged into anything, it doesn't react. The second I plug the cable into a router it crashes.
1 post • Page 1 of 1