HELP! Need to rebuild my 2big Network 2

Post Reply
slee
Posts: 2
Joined: Fri Apr 08, 2011 4:01 pm

HELP! Need to rebuild my 2big Network 2

Post by slee » Fri Apr 08, 2011 4:12 pm

I made the stupid assumption that the software for the Lacie 2Big Network was in the firmware and not on the drives. I went to replace the 1TB disks i had in it with a couple of 2TB drives. Because I needed to move a lot of data around, i formatted the old 1TB drives without thinking i might need them. Of course LaCie says that i can't just download a disk image or installer, i have to send in the whole unit for them to reformat. I dont feel like waiting for weeks for this to happen, i'd rather just set it up myself. Is there a tutorial somewhere on how to compile the GPL and format the discs?

ZZRX
Posts: 25
Joined: Thu Jan 27, 2011 8:30 am

Re: HELP! Need to rebuild my 2big Network 2

Post by ZZRX » Fri Apr 08, 2011 10:31 pm

1. You need rebuild partition table again
2. You need 2Big Network2 parition images

Check viewtopic.php?f=156&t=1652&hilit=rebuild+drive

Ramon
Posts: 1
Joined: Tue Apr 19, 2011 10:20 am

Re: HELP! Need to rebuild my 2big Network 2

Post by Ramon » Tue Apr 19, 2011 9:07 pm

I also accidentally erased the drives in my Lacie 2big network 2 2TB
I read the suggested link above but it's too difficult for me.
Can anyone of you please provide a guide/how to regarding rebuilding my drives.
I already contacted LaCie but they won't help me.
Help will be much appreciated.

Ramon

slee
Posts: 2
Joined: Fri Apr 08, 2011 4:01 pm

Re: HELP! Need to rebuild my 2big Network 2

Post by slee » Tue Apr 19, 2011 9:45 pm

I tried following the instructions in this forum, but couldn't get the sys to boot. Finally called Lacie and they sent me a new unit. Even gave me a 3tb when I had bought a 2tb. I was still under warranty

Post Reply