I ran v7 of the firmware creation script (which was hard enough having to make a Linux VM machine, fight with Linux for a while then run the script - that part was easy) to gain to extra functionality which I loaded up using the share method, sadly however it resulted in the drive just flashing blue on the front LED.
So far I've tried:
- Power off for 10 mins
A factory reset (http://www.lacie.com/support/support_ma ... deid=10454), but when it reaches the second set of blinking lights it never stops blinking!
Using the recovery mode with v2.0.6 (http://www.lacie.com/ie/support/support ... ticle=1422), after locating the drive and flashing red for a part of it it eventually returns "Unable to locate and recover the LaCie network device. Please contact LaCie Technical Support"
Has anyone else had this and if so was there a way to fix it?
Needless to say I've raised a ticket as I suspect its going back, but I'd like to avoid that if possible.