Blue/Orange flash after Firmware re-install

Post Reply
paulmorgan
Posts: 2
Joined: Mon Jan 27, 2014 12:54 am

Blue/Orange flash after Firmware re-install

Post by paulmorgan » Mon Jan 27, 2014 1:04 am

Hi

Firstly great forum and have used it extensively to help me through the issue.

Had the dreaded Blue/Orange LED Flash after powering down / up NAS drive; have connected via Linux and followed the instructions on http://iomega.nas-central.org/wiki/Inst ... ome_Media) - for system only, not data. Data is intact and can see it on linux.

However when I plug the system in I still get the blue/orange flashing LED. Using an ASUS RT-N56U router as extender to an AT&T modem - every other device is getting assigned address so am err'ing on the Iomega isn't correctly working.

Any suggestions? Thanks in advance.

Mijzelf
Posts: 6206
Joined: Mon Jun 16, 2008 10:45 am

Re: Blue/Orange flash after Firmware re-install

Post by Mijzelf » Mon Jan 27, 2014 10:41 am

The only suggestion I have is to try another cable, and to try another port on the router. If both don't help, I'm afraid your network interface is defective.

paulmorgan
Posts: 2
Joined: Mon Jan 27, 2014 12:54 am

Re: Blue/Orange flash after Firmware re-install

Post by paulmorgan » Tue Jan 28, 2014 1:35 am

Thanks for the advice - I will try it out.

Luckily my router acts as a DNLA streamer for USB attached drives (Asus RT-N56U), so worst case I'll buy an enclosure and stream that way.

Thanks for the quick reply!

Post Reply