Cannot access/map drives anymore - windows 8

StorCenter ix2-200 Network Storage
Post Reply
esieens
Posts: 2
Joined: Fri Oct 18, 2013 3:52 pm

Cannot access/map drives anymore - windows 8

Post by esieens » Sat Oct 19, 2013 8:45 am

Hi,

I have been using W8 for a while and had no problem mapping two shared folders from my iomega NAS to the W8 pc. Suddenly yesterday I could not connect to one of the share folders, then the second one too.

I get an error message that says that there is not enough storage to process this command.

I have tried to unmap one of the shared NAS folder and to remap it but I do get the same message again and cannot map it again.

Strange thing is that from time to time the 2nd shared folder which I have left map changes from disconnected to connected and I can then access its content. Everytime I reboot my pc it is first in the disconnected state and when I try to access it I get always the same error message as above. Then suddenly I'll be able to access it aftera few minutes or hours depending on the circumstances.

I have tried the registry change found on multiple websites but it did not work for me.

Any idea what else to try?

Thanks

Mijzelf
Posts: 6207
Joined: Mon Jun 16, 2008 10:45 am

Re: Cannot access/map drives anymore - windows 8

Post by Mijzelf » Sat Oct 19, 2013 10:31 am

Obvious: did you reboot the nas already?

esieens
Posts: 2
Joined: Fri Oct 18, 2013 3:52 pm

Re: Cannot access/map drives anymore - windows 8

Post by esieens » Sat Oct 19, 2013 10:37 am

ok my bad! ;)
I just did and problem went away.
Did not think this could be the problem since other machines could access the NAS just fine.
Thanks!

Post Reply