Hi guys after reading over the internet for a while i can now make this mini tutorial to help everyone that have the normal ix2-200 and wants to convert it to the new ix2-200 cloud edition, this works 100% please backup your unit because will wipe the hard drives this can also be used to fit new hard drives to the unit, after this you will have a cloud edition on latest firmware ix2-200-18.104.22.168838, so lets start.
First get a usb pen with 2gb minimum, under windows format it in fat32
After download USB INIT software from iomega here: https://iomega-eu-en.custhelp.com/app/a ... a_id/24661
Run it and select the usb pen that you just format in fat32, after finish you will have few folders on the pen, go to: emctools/ix2-200d_images and delete the file inside after that inside ix2-200d_images put the tgz file that i made for you get it from here:http://www.megaupload.com/?d=9ZFTK4MN
so now inside emctools you will have a folder called ix2-200d_images and inside that you will have a file called ix2-boot.tgz if you have this then you are ready to go, next step..
Plug the usb stick to the back lower usb port and with a clip press the reset button for 15 seconds after a min or so you will see the usb stick indicator a led should blink on your usb stick remove the clip from the reset button and wait the pen will be acessed for about 5 to 6 min then the unit will power off this means the unit its updated and ready to go, press the power button on the front and wait for about 5 min then access the unit via iomega software for cloud edition and there you go you now have a ix2-200 converted to the new cloud edition.
I did my best to explain you can read more here: http://iomega.nas-central.org/wiki/Cate ... 0-usb-init