I can post in detail any requested logs or info. The firmware installation log says that it was successful with no errors that I see, and the fvdw installation process goes very well. In the fvdw-console if I run the 'U-Boot' console instead, I get the Marvell prompt, printenv outputs a lot of info. If I run 'ide reset' it can't find any drives:
Code: Select all
Marvell>> ide reset ide reset Reset IDE: Marvell Serial ATA Adapter Found adapter at bus 1, device 7 ... Scanning channels Marvell>>
I initally wanted to use brand new 3TB seagate drives (MBR making the >2TB choice in the firmware setup), but I've also tried the original 1.5TB drives, at first only a single drive in the rightmost slot (from the back), but since other drives in other slots. All end up the same, after reboot -f, continually flashing blue disk LED, and U-Boot 'ide reset' always listing no drives or partitions.
Trying to avoid taking it apart to connect to the serial console port.