Problem after scanning volume

Marvell Kirkwood based
Post Reply
baco81
Posts: 1
Joined: Sun Jul 20, 2014 10:34 pm

Problem after scanning volume

Post by baco81 » Sun Mar 26, 2017 10:48 pm

Hello there!!!

I am trying to get some help... I scanned my first volume (disk1) using the web interface (I have two, but NO RAID setup). The problem is, something went wrong as it said "failed" and the disk1 went down according to the web. I restarted, scanned the volume again, it was successfully repaired but then, I have noted that md0 and md1 are switched. The volume that used to be md0 is now md1 and the other way around. How may I solve this? The two volumes are working, my data is there and the state says "healthy", it's just the md0 and md1 that are mounted wrong. I have access to the web, to the shell, etc. (I had to reinstall the packages, though, after the incident as they were gone :? )

BTW, I have a NSA-325 v2, fw 4.81.

Thank you very much in advance!!!

Regards!

Post Reply