General NAS-Central Forums

Welcome to the NAS community
It is currently Sat Dec 16, 2017 10:39 pm

All times are UTC




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Thu May 16, 2013 7:16 am 
Offline

Joined: Thu May 16, 2013 7:03 am
Posts: 1
Hi All,
I am new to iomega and this forum.
I am seeking your advice in the following case:

I use ix4-200d with 4 HDD Seagate Barracuda Green 2000GB (ST2000DL003). After powered on, the device is working properly for few hours and then red light starts to bling and message appears: device in downgraded mode, etc.

What I have done 1:
- verified that disks do not require any formware upgrade
- verified that disks work properly outside ix4 and formatted them
- put back all 4 disks into ix4
- ix4 started to rebuild...whatever it is
- after rebuilding applied ix4 firmware update

Result:
- red light blinking

What I have done 2:
- removed 2 disks
- repeated procedure as above
- installed only 2 disks

Result:
- red light blinking

What I have done 3:
- removed two 2TB disks and replaced them with two 500GB Hitachi Deskstar disks (HDP725050GLA360)
- repeated procedure as above

Result:
- red light blinking

This is the problem I face since 2 months and I start to HATE iomega.
Please, can anyone help me how to fix it?

Thanks
Przemek


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 9 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group