Wanted to upgrade my N2B1 to the new GUI firmware... Result not looking good. I switched it in enclosure mode one step too early (wich should not be an issue...). Now it starts up properly, has reverted to firmware 2450 and to issue is that it doesnt enable me to update firmware again (web page goes blank, NAS says firmware update for 5 minutes then comes back unchanged, tried on multiple firmwares). And I cant even reset my old hard drives, disk initialiwation starts and then blocks on HDD init...
Can anybody help?
2 posts • Page 1 of 1
Did you ever get this issue resolved? I am trying to upgrade from a 1 1T drive to 2 2T drives on N2R1DD1 and thought firmware 2450 would be the answer. I am proceeding cautiously since I don't want to lose the data on the NAS 1T drive.