led blinking blue

Post Reply
Nmas123
Posts: 3
Joined: Thu May 07, 2015 6:35 pm

led blinking blue

Post by Nmas123 » Thu May 07, 2015 6:38 pm

Hi, I have a LaCie cloudbox 2T and the led its blonking blue fast, it has been that way for 3 days, network assistant cant find anything, please can anyone help me, I'm new in this and I don't know what to do. Thx

fvdw
Posts: 777
Joined: Wed Mar 18, 2009 11:13 pm

Re: led blinking blue

Post by fvdw » Thu May 07, 2015 10:14 pm

you could try a factory reset (read the manual)

Nmas123
Posts: 3
Joined: Thu May 07, 2015 6:35 pm

Re: led blinking blue

Post by Nmas123 » Fri May 08, 2015 11:26 am

that was my fist try, but nothing happens when you try to do a hard reset the led stays blue and never turn red as the manual says and qhen you relese the button starts blinking again

fvdw
Posts: 777
Joined: Wed Mar 18, 2009 11:13 pm

Re: led blinking blue

Post by fvdw » Fri May 08, 2015 7:49 pm

Seems your disk has a problem, typically you get this blue flashing at boot time when it cannot detect the disk. This can be a software issue but also a broken hard disk.
Is there important data on your disk that you wan to recover ?
If so you could consider to use our standalone kernel (fvdw-sl) to access your disk an try to recover it. (www.plugout.net).
This kernel can be loaded using the fvdw-sl console that runs under windows and runs completely from RAM without effecting the data on your disk. If the HDD is defective then you will need to replace it and re-install lacie firmware or our fvdw-sl firmware.

Nmas123
Posts: 3
Joined: Thu May 07, 2015 6:35 pm

Re: led blinking blue

Post by Nmas123 » Fri May 22, 2015 4:31 pm

HI I don't need to recover anything from the disk, I don't know how to do that, but if the Cloudbox isn't getting any ip I don't know how I can't do anything. I you please tell me that to do.
Thank you
Best regards

dmiyabara
Posts: 61
Joined: Thu Jul 09, 2015 9:33 pm

Re: led blinking blue

Post by dmiyabara » Tue Jul 14, 2015 3:02 am

Hi fvdw,

the Lacie firmware is the file with .capsule in the final? And where should I write down the Lacie firmware using the telnet connection?

fvdw
Posts: 777
Joined: Wed Mar 18, 2009 11:13 pm

Re: led blinking blue

Post by fvdw » Tue Jul 14, 2015 9:39 pm

dmiyabara wrote:Hi fvdw,

the Lacie firmware is the file with .capsule in the final? And where should I write down the Lacie firmware using the telnet connection?
well as i do no use the lacie firmware myself (I use fvdw-sl), I am not so familiar with what is inside the capsule. Maybw the expert Myself can be helpful here.

Post Reply