Iomega EZ Copy Job Failing

Post Reply
danweis1
Posts: 1
Joined: Mon Jul 14, 2014 6:12 pm

Iomega EZ Copy Job Failing

Post by danweis1 » Mon Jul 14, 2014 6:22 pm

I have a 16 month old EZ that is failing. I've managed to put about 600gig of data on it over the months. It intermittently just drops off the network so I can't reliably copy the data off of it because it always times out at some point and fails. I think it's overheating, so I've removed it from the enclosure and that seems to have stabilized it somewhat. It seems if I leave it "alone" it stays on-line. I want to use a Copy Job to copy the data to a 1tb HD attached to the USB port. I've configured a Copy Job to do this, but I cant get it to run. Everytime I start the job, it says "Processing" forever. I've let it go for several hours and not a single bit of daya ever shows up on the external drive. Any advice would be appreciated.
Dan

Post Reply