I have a Iomega EZ Media & Backup Center 1TB with a formated disk. To install the firmware I try:
1) follow de steps on viewtopic.php?f=279&t=8317 with no luck.
2) I have an clonezilla Image of another EZ Media & Backup Center 1TB. Using this image neither work (formus said that, but I try)
3) Using the clonezilla image and write de initrd and zImage neither work
The nas never read the pendrive. So reading de init script (mount_images.sh) i see that when the nas detect a usb device the power led must blink two times or power on in white color. This never hapends...
I power on and after 4 - 10 second the power led change to red and stay there do what I do... So I'm thinking could be a hardware problem
First of all I would like to test the hardware. How can I do it???
The part of the script mount_images.sh I mention is:
Code: Select all
# if reset button is pressed do usb imaging if no usb do network imaging # else if reset button is not pressed then look for valid image in harddrive and # if not do usb imaging and if no usb drive do network imaging if [ -f $RESET_BUTTON_FILE ] || [ $USB_RECOVERY_MODE == "0" ] then # reset button was pressed rm -f $RESET_BUTTON_FILE echo "Checking if there is an attached EMC Imager" sleep 10 mkdir -p /usb_drive mount $USB_DEVICE /usb_drive -t vfat -o async,rw,fmask=0000,dmask=0000,iocharset=utf8 mount_ret=$? scriptret=0 if [ $mount_ret -eq 0 ] then # Flash the system status LED to indicate USB imaging. echo 2 > /sys/class/nasled/pwr_white_led run_preimage_script scriptret=$? extract_validate_image validate_image=$? fi if [ "$scriptret" -eq "0" ]