PX4-300D no info on LCD display

Post Reply
viostn
Posts: 2
Joined: Tue Feb 16, 2016 7:54 pm

PX4-300D no info on LCD display

Post by viostn » Thu Feb 18, 2016 2:49 am

I have bought a PX4-300d NAS storage from Ebay. It seems that it not be used at all unitl now. The device power on and working well, the only issue is that the LCD display show only the iomega logo at start up but no info after that (blank display). When I reset CMOS I can see on LCD, for a short time, the message "Low voltage CMOS battery" but nothing elese further, only iomega logo for about 10 sec. I don't know if it's the hardware or software issue. Somebody have any clue? Thanks
I forget to say that the original firmware was 3.2.3.15290, and I do the update to 4.0.2.9960 and finally to 4.1.202.33573, On both, initial firmware and latest, there are no info on LCD display. Thanks

Post Reply